Publicidad
Idiomas disponibles
Idiomas disponibles
59: The 7th gear mode is the auxiliary sleep mode: press the ③ button until the 7th indicator light turns on, it is the
•
auxiliary sleep mode. At this time, the auxiliary sleep mode function is activated, and the shaker assists the child to
sleep with a slight swing.
Warning: After the auxiliary sleep function is activated, if you switch to another swing mode, you need to press (2 in Fig.
51) again to select the swing gear, otherwise the bed will not have swing function!
Warning: When the rocking mode key (3 in Figure 51) switches to the next gear, it normally takes about 10 seconds to
switch the gear by pressing the button normally. If you don't wait for about 10 seconds to switch the button gear, there
may be a situation where you can't switch gears. This is a normal phenomenon, please use it with confidence!
WARNING: The shape of the swing track may be slightly different from the description in this manual, which is a normal
phenomenon, please use it with confidence!
The motion control key (④ in Fig.51). Press the ④ button to turn on and off the motion control link. After the baby falls asleep,
turn on the motion control mode function. For example, when the baby wakes up and shakes the crib, it can trigger the motion
control. When controlled, it will automatically trigger the 2-speed swing gear function and the music function with a lower
volume to start;
The music key (⑤ in Figure 51), the crib comes with 12 chord music, press the ⑤ key for the first time to play the music, press
the second key to turn off the music, and press the third key to enter the next song Music, so loop operation to switch music,
long press the music button when the music sounds to freely adjust the volume, and let go when the volume is adjusted to a
suitable volume;
The timing button (⑥ in Figure 51), press the button ⑥ to select the timing, press the first button until the first indicator light is
on for 15 minutes; press the second button until the second indicator light is on for 15 minutes. Timing for 30 minutes; press the
third to third indicator light to turn on the timing for 60 minutes; press the fourth time to turn off the timing function, and all
functions are turned off after the timing time. Repeat the above steps if you need to start.
The remote control function (⑦ in Fig. 51): the remote control receiver isequipped with an infrared remote control, and the
control range is about 8 meters, which can be more convenient to remotely control the shaker function.
Introduction of remote control functions (image 52):
Before using the remote control, it is necessary to pull out the power-off plastic sheet (① in Figure 52) to turn on the power of
the remote control, so that the remote control can be used normally; if the remote control is not used. When connecting the
remote controller, please insert the power-off plastic sheet to disconnect the power of the remote control, so that the power of
the remote control can be used for a longer time.
Warning: When using the remote control, you must pull out the power-off plastic sheet (① in Figure 52) and turn on the
power of the remote control, otherwise the remote control cannot be used!
•
Key ② Main power switch key: press it once, the power indicator light turns on or off.
Key ③ Music switch button: press it once, the music will sound on or off.
•
•
Key ④ Next music button: Each time you press it, the music will play to the next song.
•
Key ⑤ Previous music button: Each time you press it, the music will play to the previous song.
Key ⑥ Volume key (+): Each press can gradually increase the volume to the maximum volume set by the shaker.
•
•
Key ⑦ Volume key (-): Each press can gradually reduce the volume to the minimum volume set by the shaker.
•
Key ⑧ Swing gear key: Each time you press it, the swing gear will increase by 1 gear, and then press to 5 gears
(maximum gear) and then press to change the gears cyclically.
Key ⑨ Swing mode key: Each time you press it to switch a mode, the mode can be changed cyclically
•
Warning: When the rocking mode key (3 key in Figure 51) switches to the next gear, it normally takes about 10 seconds to
switch the gear by pressing the button normally. If you don't wait for about 10 seconds to switch the button gear, there
may be a situation where you can't switch gears. This is a normal phenomenon, please use it with confidence!
Warning: When the button is pressed until the seventh indicator light is on, the auxiliary sleep function is activated. After
the auxiliary sleep function is activated, if you switch to other swing modes, you need to press (⑧ key in Fig. 52) again to
select the swing position, otherwise sleep The bed has no swing function!
Key ⑩ Motor control key: press it once, the motor control indicator light is on or off.
•
Publicidad
