Black and Decker LDX220 Manual De Instrucciones página 11

DRILLING I NMETAL
Use acutting l ubricant when drilling m etals. The exceptions arecast i ron and brass w hich
should b edrilled d ry. T he cutting l ubricants that w ork best a re sulfurized cutting o ilorlard oil.
DRILLING I N
MASONRY
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill but
not so much that you crack the brittle material. A smooth, even flow of dust indicates the
proper drilling rate.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
Problem
• Unitwill not start.
• Batterypack will not
charge.
• Unitshuts off abruptly.
TROUBLESHOOTING
Possible Cause
• Batterypack not installed
properly.
• Batterypack not charged.
• Batterypack not inserted into
charger.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Batterypack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it isdesigned
to shutoff abruptly when
the charge is depleted.)
Possible Solution
• Check battery pack
installation.
• Check battery pack charging
requirements.
• Insert batterypack into
charger untilgreen LED appears.
• Plug charger into a working
outlet. Refer to "Important Charging
Notes" for more details.
• Move charger and battery
pack to a surrounding air temperature of
above 40 degrees F (4.5°C) or below
105degrees F (+40.5°C).
• Allow batterypack to coot
down.
• Place on charger and
allow to charge.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
ACCESSORIES
Recommended accessories for use with your toot are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
-&WARNING:
The use of any accessory not recommended for use with this tool could be
hazardous.
The RBRC
TM
Seal
The RBRC
TM
(Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Black & Decker. In some areas, it is illegal to place spent lithium-ion batteries
in the trash or municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by returning the
toot to an authorized Black & Decker service center for recycling. You may also contact
your local recycling center for information on where to drop off the spent battery, or cal
1=800=8=BATTERY.
11