Black and Decker LDX220 Manual De Instrucciones página 8

c.Move charger andbattery p ack toa location where thesurrounding air
temperature isapproximately 65°F - 75°F (18 °-24°C).
d.Ifcharging problems persist, take thetool, b attery p ack and charger toyour
local service c enter.
4.The battery p ack should berecharged when itfailstoproduce sufficient power o n
jobswhich were easily done previously. DONOT CONTINUE touseunder t hese
conditions. Follow thecharging procedure. You may also charge a partially used pack
whenever youdesire w ithnoadverse a ffect onthebattery p ack.
5.Foreign m aterials ofaconductive nature s uch as,butnotlimited t o,steel w ool,
aluminum f oil,oranybuildup o fmetallic particles should b ekept a way f rom charger
cavities. Always u nplug t hecharger from thepower supply w hen there isnobattery
pack inthecavity. Unplug charger before a ttempting toclean.
6.Donot f reeze or immerse charger inwater o ranyother l iquid.
zLWARNING:
Shock hazard. Do not allow any liquid to get inside charger. Never
attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks or cracks, return to a service center for recycling.
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
1. Hold drill firmly with one hand on the grip and the other hand on the bottom of the
battery pack.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck firmly.
_WARNING-" Drill may stall (if overloaded or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly with both hands to control the twisting action and
prevent loss of control which could cause personal injury. If a stall does occur, release
the trigger immediately and determine the reason for the stall before re-starting.
INSTALLING AND REMOVING THE BATTERY PACK FROM THE TOOL
z_ WAR N IN G: Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack into
tool until an audible click is heard (figure B). Make
sure battery pack is fully seated and fully latched into
position.
TO REMOVE BATTERY PACK: Depress the battery
release button as shown in figure C and pull battery
pack out of tool.