Black and Decker LDX220 Manual De Instrucciones página 9

OPERATING iNSTRUCTiONS
TRIGGER SWITCH & REVERSING BUTTON
The drill is turned ON and OFF by pulling
and releasing the trigger switch (1). The
farther the trigger is depressed, the higher
the speed of the drill.
A forward/reverse control button (2)
determines the direction of the tool and
also serves as a lock off button.
To select forward rotation, release the
trigger switch and depress the
forward/reverse control button to the left.
To select reverse, depress the
forward/reverse control button the opposite
direction.
NOTE: The center position of the control
button locks the toot in the off position.
When changing the position of the control
button, be sure the trigger is released.
FIGURE D)
®
TORQUE CONTROL (FIGURE E)
This tool is fitted with a torque adjustment _'_
collar (3) to select the operating mode and to
set the torque for tightening screws. Large
screws and hard workpiece materials require
a higher torque setting than small screws and
soft workpiece materials.
For drilling in wood, metal and plastics, set
the collar to the drilling position symbol
For screwdriving, set the collar to the
desired setting. If you do not yet know the
appropriate setting, proceed as follows:
Set the collar to the lowest torque setting.
Tighten the first screw.
If the clutch ratchets before the desired
result is achieved, increase the collar setting and continue tightening the screw.
Repeat until you reach the correct setting. Use this setting for the remaining screws.
KEYLESS CHUCK (FIGURE F)
zLWARNING:
Make certain the Iock-off button is engaged to prevent switch actuation
before installing or removing accessories.
To insert a drill bit or other accessory: f'_
1. Grasp the rear half of the chuck (4) with
one hand and use your other hand to
rotate the front half (4a) in the
counterclockwise direction, as viewed from
the chuck end.
2. Insert the bit or other accessory fully into
the chuck, and tighten securely by holding
the rear half of the chuck and rotating the
front portion in the clockwise direction as
viewed from the chuck end.
zLWARNiNG:
Do not attempt to tighten drill
bits (or any other accessory) by gripping the
front part of the chuck and turning the toot on.
Damage to the chuck and personal injury may occur when changing accessories.