UFESA CV Polux Nano Manual De Instrucciones página 20

ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the carton), must be fitted to the unit.
These are to be attached to the base of the heater using the 2 screws provided, taking care
to ensure that they are located correctly in the bottom ends of the heater side moldings
OPERATION OF THE HEATER
NOTE: - It is normal when the heaters are turned on for the first time or when they are turned
on after having not been used for a long period of time the heaters may emit some smell and
fumes. This will disappear when the heater has been on a short while.
This appliance can be operated by the manual controls located on the side of the heater:
Thermostat de knob
Heater switch
Turn the thermostat knob in a clockwise direction until it reaches the maximum setting.
Turn on the heating elements by means of Heater Switch on the side panel.
You may obtain three heating settings (I=750W/ II=1050W /III=1800W) by turning the heater
switch knob in a clockwise direction.
Speed selector
[ 0 ] – OFF
[ I ] – Power I
[ II ] – Power II + Fan
[ III ] – Power III + Fan
Fan Operation
The fan will only operate after turning the thermostat knob clockwise and hearing click on.
Plus, the heating elements must be " " or " ". Upon that, heater can blow warm air into the
room.
When the desired room temperature has been reached, the thermostat knob should be turned
slowly anti-clockwise until the thermostat is heard to click off. After this the heater will keep
the air temperature in the room at the set level by switching on and off automatically.
20