Publicidad
Idiomas disponibles
Idiomas disponibles
Type of current for the motor
• Machine data - type plate
• Machine data - type plate
15. Troubleshooting
Problem
Possible Cause
Saw blade gets loose
Fastening nut tightened insufficiently
after turning off the
motor
Motor does not start
a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch defect
No motor output turns
Overload by dull saw blade, thermoprotection
off automatically
is triggered
Burns on the cutting
a) Fastening nut tightened insufficiently
surface
b) Wrong saw blade
c) with longitudinal cuts
c) Longitudinal stop not parallel
d) with cross cuts
d) Slide carriage not parallel
26 І 220
26 І 220
Help
Tighten fastening nut, M20 left-handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the operating
manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be turned
on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade
Publicidad
