Publicidad
Idiomas disponibles
Idiomas disponibles
Operation / Cleaning
Push the plain washer and spring on to a new engraving point
Then insert this and turn the engraving point holder
to lock the engraving point in position.
Ensure that the engraving point
Advice on use
You can use the mini-engraver to produce creative, individual engravings.
For example, you can use it to place identifying marks on your valuables.
You can engrave numbers and letters into metal, glass, wood, plastic,
ceramic, stone and leather. This is done with the help of the supplied
engraving stencils
Hold the device at an angle, as you would a pencil.
Your arm should rest on the table.
Using very light pressure, guide the engraving point
workpiece. Find the ideal speed of movement by trial and error on
a piece of waste material.
Note: The engraving point
from tungsten steel. Therefore it is not suitable for engraving electronic
media such as CDs, DVDs etc. It could damage these materials and
render them illegible.
Cleaning
work, always remove the mains plug from the socket.
Clean all the dirt off the device. Use a dry cloth for cleaning.
62 GB/MT
, see Figs. A and B.
7
supplied with the product is made
5
Before performing any cleaning or maintenance
is properly fixed in position.
5
.
5
clockwise
6
over the
5
Publicidad
