cecotec Cumbia POWER ESPRESSO 20 MATIC Manual De Instrucciones página 20

ENGLISH
Steam and froth function
- Press the steam button. The indicator light will turn red and flash. Once the preheating
process is over, the light will stop flashing.
- Fill a small jug one third full with milk, insert the milk-frother nozzle and turn the steam
knob carefully.
ATTENTION:
- It is suggested to release some steam before frothing milk.
- It is recommended to use cold whole milk for optimal results.
- The milk frother angle can be adjusted.
Clean the steam outlet with a wet sponge immediately after use. Then, remove the milk
-
frother and clean the duct interior part. It is also recommended to emit steam again to
clean possible milk remaining inside the tube.
Hot water function
- Press the power button, the indicator light will turn blue indicating that the machine is
preheating. Once the light stops flashing, the machine is ready.
- Turn the knob to the ON position, hot water will be dispensed. This hot water can be used
for cleaning, warming cups, drinking, etc.
- Turn the knob back to OFF to turn the machine off.
4. CLEANING AND MAINTENANCE
Unplug the coffee machine and wait for it to cool down before cleaning. Do not immerse
-
the product in water or any other liquid during cleaning.
- Failure to maintain the product in clean conditions could lead to surface deterioration and
could adversely affect the product's shelf life.
Never use strong detergents, petrol, abrasive powders, or a metal brush to clean any part
-
of the product.
- After frothing milk, use a dampened soft cloth to clean the milk frother and the nozzle, and
allow some steam to come out to prevent the inside part from blocking due to dry milk.
A complete cleaning cycle is suggested every 3 months. Carry out the following steps:
-
1. Fill up the water tank, add a commercial descaler according to the proportions suggested
by the manufacturer, and carry out a full cleaning cycle.
2. Repeat the before step again only with water to rinse the machine's inside and remove all
the cleaning product residue.
38 POWER ESPRESSO 20 MATIC
5. TROUBLESHOOTING
If you experience any problem with the appliance or you think it does not work properly, you
can carry out a few simple checks before calling the official Cecotec Customer Service.
Problem Possible causes
Coffee does not No water in tank.
come out. Coffee grind is too fine.
There is too much coffee in the
filter.
The device is not turned on or
connected to the power supply.
Coffee has been tamped/
compressed too much.
No coffee comes out and/or
there's no pressure.
Coffee comes Portafilter not rotated to full lock
out around the position.
edge of the There is ground coffee on the edge
portafilter. of the filter.
There is too much coffee in the
filter.
Coffee comes Ground coffee is too coarse.
out too quickly. Not enough coffee in filter.
Coffee is not properly tamped.
WARNING:
Do not try to repair the appliance on your own. If the problem persists after the checks
explained, contact a qualified electrician, authorised personnel, the store where you purchased
the product, or the official Customer Service of Cecotec.
6. TECHNICAL SPECIFICATIONS
Model: Power Espresso 20 Matic
Product reference: 01509
Power: 850 W
Voltage and frequency: 220-240 V~, 50/60 Hz
ENGLISH
Possible solutions
Add water.
Grind medium-ground coffee.
Fill filter with less coffee.
Connect the unit to a power supply
and turn it on.
Refill the filter basket with coffee, do
not tamp too much.
Carry out a full descaling of the
device.
Rotate filter holder to full lock
position.
Wipe off the rim.
Fill with less coffee.
Use a finer grind.
Use more coffee.
Fill the filter with coffee and tamp it
harder.
POWER ESPRESSO 20 MATIC 39