Publicidad
• Incorrect use or assembly or prohibited by the manufacturer.
• Poor maintenance.
• Modification to the machine.
• Use of non-genuine spare parts (adaptable parts).
• Use of accessories not supplied or approved by the
manufacturer.
The warranty does not cover:
• Maintenance operations (described in the instruction
manual).
• Normal wear and tear of consumables, such as cutting
means, safety bolts and cabling.
• Normal wear and tear.
12. PROBLEM IDENTIFICATION
If problems persist after having performed the above operations, contact your dealer.
PROBLEM
The motor does not start when
1.
the switch is pressed
The motor is running but the
2.
cutting means is stationary
The motor shuts down whilst
3.
working.
The motor shuts down whilst
3.
working.
PROBABLE CAUSE
Safety key is not inserted or is inserted
incorrectly.
Battery is not inserted or is inserted incorrectly.
Low battery.
Motor start-up is slow.
The thermal protection has tripped
due to overheating of the motor.
The cutting means fittings are loose.
Battery is not inserted correctly.
Low battery.
Obstructions that prevent rotation
of the cutting means.
The thermal protection has tripped
due to overheating of the motor.
Thermal protection has tripped due to
excessive current absorption caused by:
• Excessively high grass cutting.
• Obstructions that prevent rotation
of the cutting means.
• Too much grass debris accumulated in
the chassis and discharge channel.
• Deterioration in the appearance of the machine due to use.
• Cutting means supports.
• Any ancillary expenses related to the enforcement
of the warranty, such as costs incurred to travel to
the user's location, transfer of the machine to the
Dealer, rental of replacement equipment or calling of
independent enterprises to perform maintenance work.
The user is protected by his or her own national legislation.
The user's rights under the national laws or his or her own
country are not in any way restricted by this warranty.
Insert the key
Open the hatch and check that the battery is
fitted in its housing correctly (Fig. 6.B)
Check the battery status and recharge
if necessary (par. 7.1.2).
Press and hold the control lever for 2-3 seconds (par. 5.2).
Wait for at least 5 minutes and then restart the machine.
Immediately turn off the motor and remove the safety key.
Contact an authorised Technical Assistance Centre
for checks, replacements or repairs (par. 7.3).
Open the hatch and check that the battery is
fitted in its housing correctly (par. 7.1).
Check the battery status and recharge
if necessary (par. 7.1.2).
Remove the safety key, put on your work gloves and
remove any grass remains or debris from the lower
part of the machine and/or the discharge channel.
Clean the cooling air intake vents (par. 7.2.3).
Wait for at least 5 minutes and then restart the machine.
• Remove the obstructions (par. 7.2.2).
• Clean the machine (par. 7.2.1, 7.2.2, 7.2.3)
Wait for at least 5 minutes and then restart the machine.
EN - 8
SOLUTION
(Fig.
6.C).
Publicidad
