20.
ADVICES
READ THE INSTRUCTIONS FOR THE INSTALLER, OPERATION AND MAINTENANCE BEFORE INSTALLING THE
EQUIPMENT. IMPROPER INSTALLATION, ADAPTATIONS OR MODIFICATIONS MAY CAUSE DAMAGE TO
PROPERTY OR PEOPLE. INTENTIONAL DAMAGE OR DAMAGE DUE TO NEGLIGENCE OR RESULTING FROM THE
FAILURE OT RESPECT THE INSTRUCTIONS OR STANDARDS OR DUE TO INCORRECT CONNECTIONS OR
UNAUTHORISED TAMPERING SHALL ANNUL ALL WARRANTIES OR MANUFACTURER LIABILITY
•
Read this manual carefully as it provides important information concerning installation, user and maintenance safety.
Store this manual careful for future consultation by the various operators.
•
Installation must be carried out according to manufacturer instructions by professionally qualified personnel,
according to current law.
•
The equipment may only be used to personnel who have been trained and instructed by a manager who guarantees
its safety.
•
Switch off the equipment in the event of a fault or poor operation;
•
Children must be supervised to make sure they do not play with the appliance.
•
The appliance is not intended for use by people (including children) with reduced physical, sensory or mental
capabilities.
For any repairs, only contact a service centre authorised by the manufacturer and demand original spare parts.
21.
TRASPORT
Any moving of the equipment requires the use of a suitable vehicle: a lift truck or a fork pallet truck.
22.
UNPACKAING
Wear protective gloves and remove the packaging. Lift the equipment with min. 2 people, remove the base and position it
at its destination. Remove the protective film and make sure the packaging material is disposed of properly following the
current standards in the country of product use.
23.
DISPOSAL
All of the packaging material is compatible with the environment. It may be kept without danger, can be recycled or burnt
in a specific waste combustion system. Plastic components that can be recycled are marked as follows :
Polyethylene external
packagingfilm,instructions bag
pag. 17
Polypropylene Straps
Expanded polystyrene.Protective
angle bars
DOC. W010215 – REV.2