Publicidad
Idiomas disponibles
Idiomas disponibles
36. END OF SERVICE AND DAILY CLEANING
The machine can perform an automatic cleaning cycle to make it easier to remove any residues and guarantee greater
hygiene over time:
Aprire Open the door and remove the basket with the clean dishes.
•
•
Close the door and press the drain button.
•
Wait a few minutes until "End of cycle" appears on the display.
The machine turns off automatically
•
JETS CLEANING
Remove the upper jets "P" by unscrewing the ring nut "Q" with your fingers
•
•
Lift up the rinsing jet "P", unscrew the plugs "R" from the jets and clean everything with a jet of water. Do not clean the
nozzle openings with tools or pins, as they could damage them.
WARNING !! (cleaning the outer surfaces)
Before starting with cleaning operations, disconnect the equipment's electric power supply located on the electric
•
panel, remembering that the machine remains powered when only the switch on the control panel is turned off.
•
Wash the stainless steel surfaces with warm soapy water, avoiding the use of detergents that contain abrasive
substances, scourers, brushers or steel scrapers, then rinse with a wet cloth and dry carefully.
Clean the control panel with a soft cloth moistened with water and, if necessary, neutral detergent. Do not wash the
equipment with direct or high pressure jets of water
The equipment must not be cleaned with water jets. In order to reduce the release of polluting substances to the
•
environment, it is recommended to clean the equipment with products that have a level of biodegradability above
90%.
Leave the door open for the entire period the machine will not be used.
pag. 27
DOC. W010215 – REV.2
Publicidad
