Publicidad
Idiomas disponibles
Idiomas disponibles
EN
ADAPTIG TIG WELDING TORCH
DECLARATION OF CONFORMITY
Trafimet Group Spa, a duly registered Italian Manufacturing Company, located in Via del Lavoro, 8 36020 Castegnero (VI),
hereby declares that products identified and described in this manual are in conformity with the provisions of the Low Voltage
Directive 2014/35 EU the products and in compliance with the standards set by EN 60974-7 Arc Welding Equipment - Part 7.
EN 60974-7
Trafimet Group Spa, a duly registered Italian Manufacturing Company, located in Via del Lavoro, 8 36020 Castegnero (VI),
hereby declares that the products identified and described in this manual comply with the provisions of the Electrical
Equipment (Safety) Regulations 2016 and the Restriction of the Use of Certain Hazardous Substances in Electrical and
Electronic Equipment Regulations 2012.
IMPORTANT NOTES
Read through the instructions carefully. For your own safety, and that of your working environment, pay particular attention to the
safety instructions delivered with the equipment.
Dispose of this product responsibly after use. Torches and used parts should be properly recycled according to local requirements
and regulations.
Disconnect the power source from the mains power supply before handling electrical cables or performing torch maintenance.
Before connecting the torch, switch off the power source, disconnect the power plug and turn off the gas supply.
Always use original Trafimet spare parts and consumables.
Items in the manual that require particular attention in order to minimize damage and harm are indicated by the symbols shown below.
Read these sections carefully and follow the instructions.
Note: Provides useful information
Caution: Describes a situation that may result in damage to the equipment or system.
Warning: Describes a potentially dangerous situation. If not avoided, it will result in personal damage or fatal injury.
ABOUT THE EQUIPMENT
Adaptig is a configurable high-end TIG welding torch designed for inert gas arc welding with tungsten electrodes. The Adaptig selection
range consists of several different torch bodies, torch remote controls and more than 400 power source connection options. The available
torch cable lengths are 4, 8 and 16 meters. You configure the Adaptig TIG Torch for your specific welding needs using Trafimet's online
torch configurator tool at the welding torch is delivered to you fully assembled.
The equipment includes the following elements (the exact visual details may differ between different torch models):
1) Torch body and neck
2) Electrode back cap
1
3) Welding cable
4) Handle with adjustable
finger supports
5) Welding switch (and welding
torch remote controls, if
applicable)
2
1
For multi-function generators where the use of the EURO type connection is required, the Adaptig TIG torch can only be used in
"Lift Arc" mode. It is forbidden to use it in "High Frequency (HF)" mode.
Rating of electrical controls incorporated in the torch: Control button 0.05A (32VDC) / Potentiometer (if provided) 0.25W @70°C.
All trademarks are the property of their respective owners. The information and images are indicative and may be subject to change at any time without notice.
6) Gas nozzle
1
7) Collet body
1
8) Collet
1
9) Insulating ring
9
8
7
5
6
3
4
© 2023 Trafimet Group SpA
10) Main welding connector
(current)
2
2
11) Shielding gas cable
12) Control cable
13) Coolant hoses (water-
cooled torches only)
These consumable parts are not included in the standard delivery.
1)
Configured according to the power source setup. For example, if the
2)
controll signal and shielding gas line are integrated into one welding
connector on the power source, a corresponding connector adapter
kit needs to be used.
2
2
13
10
11
12
Publicidad
