rcf L-PAD 6X Manual Del Usuario página 6

FUNCTIONS
PAN or BAL: This control defines the signal stereo imaging for mono channels or left‑
right balance for stereo channels.
KNOBS Ch. 1 - Ch. 2: MONO Channels level control
KNOBS Ch. 3/4 - Ch. 5/6: STEREO channels level control
MAIN MIX output: Unbalanced TRS jack. Plug in your active speakers or main sound
reinforcement system amplifier (for passive speakers) of here.
CONTROL ROOM output: Plug your studio monitor or local speakers into these TRS
jacks.
FX SEND output: Plug a wedge stage monitor or external FX device into this TRS jack.
The processed signal from the FX device is returned to the RCF mixing consoles mixer
via the Stereo Return jacks.
PHONES: TRS stereo jack, Tip = Left, Ring = Right, Sleeve = Common Earth. Plug in your
headphones here to listen to MAIN MIX or PFL when pressed.
FOOTSWITCH: TS connector, Tip = FX, Sleeve = EARTH. Connect a footswitch here.
Press once to bypass the internal FX, press again to resume the FX. The same function is
available for the FX MUTE button.
FX SELECTION: This 16‑position selector can be used to select one of the 16 preset
effects available on the internal DSP. See the FX LIST to select the required effect.
FX MUTE button: This switches the FX return signal on and off alternatively (see the red
LED PEAK/MUTE). The function is the same as the FOOTSWITCH input jack.
+48 V PHANTOM POWER ON-OFF switch: This switches the microphone input phantom
power on and off. It must be employed when condenser or electret microphones are
used.
OUTPUT LEVEL: These leds shows the level of the MAIN MIX OUTPUT. Keep under CLIP
level to prevent generating distorted sounds or dangerous sound levels.
FX TO MAIN control: This defines the FX return level routed to the MAIN MIX output.
STEREO RETURN control: This defines the STEREO RETURN input signal level routed to
MAIN MIX output.
2TK IN control: This defines the signal level from the 2TK IN.
TO MAIN MIX/TO CONTROL ROOM switch: Defines where to route the signal coming
from 2TK IN: to MAIN MIX when in upper position, to CONTROL ROOM when pressed
(lower position).
PHONES/CONTROL ROOM control: This defines the signal level routed to CONTROL
ROOM output and PHONES output.
MAIN MIX KNOB: MAIN MIX output level control.v
6