Cleaning Instructions; Technical Description - Reliable SENZA 200DS Manual De Instrucciones

AFTER IRONING
Set the temperature control knob (L) to "min" and unplug it from the electrical
outlet. Let the iron cool down on its stand (D). Empty the tank: open the tank
filling cover (H), overturn the iron and let water drain (Fig. 21).
WARNING: Let the iron cool down before emptying the tank.
Store the power cord in the cord storage compartment (Y). Put back the cable
connecting the iron to the tank in the cord storage compartment (X). Let the iron
cool down on its stand, taking care not to touch the power cables and connection
with the hot parts of the appliance.
MAINTENANCE OF THE BOILER
To maintain your steam ironing system in good condition and to ensure consistent
performance, we recommend that you periodically clean the boiler once or twice a
year depending on the hardness of the water.

CLEANING INSTRUCTIONS

ATTENTION: Before cleaning the boiler, please make sure that the boiler is at room
temperature and that it has not been used for at least 8 hours, and that the boiler
is disconnected from the power source.
Do not unscrew the boiler cap (V) with the appliance in its working position, as this
may cause the water in the boiler to escape unexpectedly (Fig. 16).
Place the appliance so as to obtain the tank-cleaning cap (V) on the top (Fig. 17).
Open the door (W). With a flathead screwdriver, unscrew the tank cleaning cap (V).
Overturn the appliance on a sink and completely drain the tank (Fig. 18).
Place one measuring cup of tap water in the boiler (Fig. 19). Using a de-scaling
powder (can be purchased at www.reliablecorporation.com), pour the contents of
the package into the filled (with water) boiler, let it sit for a few hours, then rinse
3-4 times.
Repeat this operation until the water coming out of the boiler is clean and clear.
After cleaning the boiler, pour approximately 400ml of water into the boiler (Fig.
19) and refit the cap (V) tightening it slightly, without forcing it excessively. Close
the door (W).

TECHNICAL DESCRIPTION

120V Power 1750W
Cold water tank capacity 1L
Working pressure 3.5bar
12