Reliable SENZA 200DS Manual De Instrucciones página 7

• If an extension cord is absolutely necessary, a cord with an ampere rating equal to
or greater than the maximum rating of the iron shall be used. A cord rated for less
amperage can result in a risk of fire or electric shock due to overheating. Care shall
be taken to arrange the cord so that it cannot be pulled or be tripped over.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory, or mental capabilities, or lack or experience or knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised so that they do not play with the appliance.
• The iron is not to be used if it has been dropped, if there are visible signs of damage
or if it leaking.
• Use caution when turning the steam iron upside down, there might be hot water in
the reservoir.
• Place the appliance on a work surface that bears a temperature of at least 90°C
• Never put away your steam iron while it is still hot. There is no need for emptying the
tank unless you intend to leave it unused for a long period of time.
SAVE THESE INSTRUCTIONS
• ATTENTION: Please make sure that before you begin ironing, you wait for the steam
ready light to light up. If it does not, please call contact an authorized service depot
before using.
• This product is intended for household use only – maximum 15-20 hours per week.
Follow all user instructions in this manual. Please do not leave the hot iron on the
iron rest (that sits on top of the boiler) unattended or for a period longer than 1 hour.
If the iron needs to stay on for longer than 1 hour, reduce the temperature to the
lowest setting.
FAILURE TO FOLLOW THESE INSTRUCTIONS WILL
VOID THE WARRANTY.
WATER INSTRUCTIONS
Your steam iron system has been planned for use with normal tap water. In
order to extend the life of this product, if where you are living the level of water
hardness is very high, we recommend to use 50% of normal water with 50% of
demineralized or distilled water. Do not use softened water or well water.
TEST FIRST, THEN IRON
Prior to ironing on delicate fabrics, it is a good idea to do a test in a hidden area
(like the reverse side) to ensure that no damage is done to the fabric. We will not
assume any responsibility in case you do not comply with these instructions.
04