Step 2 - Route Drain Hose (Optional) - Haier HLP21N Manual Del Usuario

a
•
Using two or more people, lift the washer off of the packing base and the
molded plastic support.
NOTE: It is possible for the plastic support, under the U bracket, to remain
attached to the bottom of the washer. Make sure it is removed with the foam
base.
2. Inspect the washer, and remove any remnants of packaging, tape or printed
materials before using the washer.
3. Properly dispose of /recycle all packing material.

STEP 2 - ROUTE DRAIN HOSE (OPTIONAL)

The washer comes from the factory with the drain hose routed so that it extends
from the bottom, left-hand side of the washer. If you want the hose to extend from
the right-hand side of the washer for draining, you must reroute the hose.
1. Remove the hose clamp. Gently pull the drain hose back through the opening on
the left-hand side of the washer.
2. Insert the drain hose into the opening on the right-hand side of the washer and
gently extend the hose to its full length.
12
a
Wash Basket Brace
a
a
b
b
Plastic
Support
Foam
Base