Drain Hose; Power Supply Connection - Haier HW80-BD1626 Manual Del Usuario

Installation
Inlet hose - Aqua control System
The Aqua Stop inlet hose is an important element for safety
and over all control. Its valves are controlling water supply
and will interrupt it if the hose is leaking
Connect the nut on the inlet hose to the connector
on the water valve.
Apply inlet hose to a water tap.
Warning!
Appliance is only qualified for cold water supply!
Use the hose-set supplied with the appliance.
Old hose-sets should not be reused.

Drain hose

Drainage could be installed in different ways. Nevertheless,
level of drain hose has to reach at one point 80-100 cm.
If possible keep always drain hose fixed to the clip at the
appliance back.
1. Drain hose to sink
Use the drain hose bracket to keep drain hose end retained
and out of any water level.
Fix the bracket sufficiently to avoid dropping down due to
operational movements.
2. Drain hose to sink siphon
Connection has to be securely sealed and fixed to corres-
pondig adapter above the siphoning part!
80 - 100 cm
24 25
3. Drain hose to sewage pipe
Use the drain hose bracket to keep drain hose end retained.
Fix the bracket sufficiently to avoid dropping down due to
operational movements.
Warning!
The drain hose should not be submerged in water and should be
securely fixed and leak-free. If the drain hose is placed on the
ground or if the pipe is at a height of less than 80cm, the washing
machine will continuously drain while being filled (self-siphoning).
Drain hose is not to be extended. If necessary contact after sales
service.

Power supply connection

Before each connection check if:
- socket is adequate for the maximum power of the
appliance (safety power circuit fuse should be
rated not less than 15A).
- voltage should meet the requirement.
- power outlet should be appropriate to appliance plug.
- used power socket has to be earthed.
Installation