Publicidad
EN
Congratulations on your new inflatable product purchase!
Please read all instructions carefully before use.
Warnings
● Air leaks occur from all joints, but this is necessary because the
inflatable bounce house is inflated through a constant airflow, and this
leakage is required to prevent over-inflation of the product.
● Before inflated the Bouncer, Pls Check the ground where the bouncer
is be inflated to prevent the bottom from being punctured by hard objects.
Do not install the bouncer over concrete, and prohibit violent dragging
and moving.
Precautions
● Ensure electrical source is safe and stable before operation.
● Keep children away from blower. Do not insert fingers, toes, etc into the
blower, or it may cause injury.
● Do not insert foreign objects into the blower. This will cause damage.
● Do not bring sharp objects into play area.
● Do not eat in play area.
● Do not smoke in play area.
● Keep product away from fire and heat.
● In case of blower malfunction, tighten blower vent and evacuate play
area immediately.
● Do not use in rain, strong wind or extreme weather conditions.
● Observe precautions on product WARNING LABEL at all times.
10
Set up
● Product should be assembled by an adult.
● Unroll product evenly across smooth, flat, debris-free surface. Connect
blower(s) to inlet, and tie. Anchor the blower to the ground using the
stakes provided.
● Plug in and start blower.If your item uses multiple blowers, connect all
blowers to their inlets. Make sure all blowers are powered off (blower
models with switch). Plug in all blowers, then switch them on
one-at-a-time at 20 second intervals.
● Once inflated, anchor the inflatable product to the ground using the
stakes provided.
Disassembly
● Ensure that all the players have left play area.
● Remove any loose articles or debris from play area.
● Turn off and unplug blower.
● Once product is fully deflated, fold & store in a cool, dry area.
Maintenance & Repair
● Always keep products clean to protect the seams and surface.
● Regularly inspect seams and play surface for any necessary repair.
Slight damage caused by nature or man-made factors can be repaired
with the repair kit provided.
● To repair, deflate the product thoroughly, and ensure surface is dry. Cut
patches to sizes suitable for repair. Apply glue on both the repair patches,
and the damaged surface. Allow the glue to air-dry for 30 seconds before
adhering the patch to the play surface. Allow to dry for at least 4 hours
before use.
NOTE: Maximum weight of user : 45 kg each.
11
Publicidad
