Publicidad
Idiomas disponibles
Idiomas disponibles
Loadingandusing thedryer.
Always follow the fabric manufacturer's care label when laundering.
FabricCareLabels
Below are fhbri( (are label "symbols" dlat afle(t the ( lothing you _dll be laundering.
WASH LABELS
DRY LABELS
OentlsJ
_1, ms
cycle
Normal
pemlanent
press/
Bo]]ot
wash
Oo not wring
wrinHe
resistant
delicate
h
Water
•
•
•
• •
•
temperature
Hot
W .....
Cold/cool
(50 'C/120' F)
(40' C/105'F)
(30' C/85"F)
BLEACH LABELS
--
Bo i1_ dry
BB'
Normal
Pefrllanent
Pfe_sJ
gentle/
Do not tmllble
dry
_tlsed with
wrinkle
reeistarlt
delicate
do iiot wash_
setting
High
Medium
Low
Noheat/air
[]
[]
Pq
Une dr_J
gripdry
Dryfla_
h,the s_de
h_ngto dry
Bleach A
symbols
_11_ b]8_
Only non chlom,e
bleach
Be not bleach
Iwhen needed}
[wh ell i1eeded)
Sortingand LoadingHints
As a general rule, if clothes me sorted properly lot tile washer, tile} me sorted properly lot tile (hyer.
T U also to sort items according to size. For example, do not d U a sheet with socks or other small items.
Donotaddfabricsoftenersheetsoncetheloadhasbecome warm.They maycause fabricsoftenerstalbs.
Bounce_ F abnc Conditioner DryerSheets havebeenapproved forusein aft GE Dryerswhenusedin accordance w ith the
rnanufacturer# i nstructions.
Do not overload.Thiswastesenergy andcauses wrink/tbg.
Do not dry the following#ems: fl#erg/ass / terns, w oolen&rubber-coated/tern& plastic&/terns withplastictnmand
foam-filled/terns.
Care and Cleaningof the Dryer
TheExterior: Wipe or dust any spills or w,Mling
compounds
_dth a dmnp cloth. D_Ter conu'ol
panel and finishes IIlay be damaged by SOIlle
lmmd U preueatment
soil and stain remover
pro(h_cls. Apply these products axva}fiOlil the
duet. The Ltbric m W then be washed and dried
normally. Dmnage to your &Ter cm_sed by these
products is not c()vered by your warran U.
The Lint Filter:Clean the lint fiher beiore each
use. Moisten your fingers and reach into the fiher
opening. Run y()ur fingers across the filmr. Have a
qualified technidan
x_ltuum tile lint flom tile (hyer
OllCe a
year.
TheExhaust Duct: Inspect and clean tile exhaust
ducting at least once a year to prevent (logging. A
partially ch)gged exhaust can lengthen the (h):ing
time.
Follow these steps:
[_ Turn off electrical mpplv bv disconnecting
tile
plug ][i'OlIl t ile wall socket. •
[_ Disconnect tile duct fiom tile (hTer.
[_ Vacuum the (lt](7[with tile hose attachment
and
reconne( t the duct.
TheExhaust Hoe&Check xdth a mirror that tile inside
flaps of the hood move fleely when operating. Make
sure that there is not xdldlife (birds, insects, etc.)
nesting inside tile duct or hood.
15
Publicidad
