Publicidad
Idiomas disponibles
Idiomas disponibles
Application Guidelines/Water Supply Parameters
Service Flow
0.5 gpm (1.9 Ipm)
Water Supply
Potable Water
Water Pressure
20 -120 psi (138 - 827 kPa)
Water Temperature
33°F - 100°F (0.6°C - 38°C)
It is essential
that the manufacturer's
recommended
installation,
maintenance
and filter replacement
requirements
be carried out for the product to perform
as advertised.
Note: While the testing was performed
under standard
laboratory conditions,
actual performance
may vary.
Replacement
Filter: ADQ36006102
For estimated
costs of replacement
elements
please
call 1-800-469-4663
or visit our website at
www.sears.com/partsdirect
3M is a trademark of 3M Company.
NSF is a trademark of NSF International.
© 2009 3M Company. All rights reserved.
To reduce the risk associated
with ingestion
of contaminants:
Do not use with water that is
microbiologically
unsafe or of unknown
quality without
adequate
disinfection
before
and after the system.
Systems
certified for cyst
reduction
may be used on disinfected
water that
may contain filterable
cysts. EPA Establishment
Number 10350-MN-005
To reduce the risk associated
with property
damage due to water leakage:
• Read and follow
Use Instructions before
installation and use of this system.
• Installation and use MUST comply with all state
and local plumbing
codes.
• Do not install if water pressure exceeds 120 psi
(827 kPa). Contact a plumbing
professional
if you
are uncertain how to check your water pressure.
• Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing
professional
if you uncertain how to
check for this condition.
• Do not install on hot water supply lines.
The maximum
operating
water temperature
of this
filter system is 100°F (38°C).
• Protect
filter from freezing.
Drain filter when
temperatures
drop below 40°F (4.4°C).
• The disposable
filter must be replaced every
6 months or more often depending
on useage.
30
Publicidad
