Publicidad
Idiomas disponibles
Idiomas disponibles
LIGHTS DO NOT WORK
Check if...
Then...
The power supply cord is unplugged.
LED interior lighting failure.
Firmly plug the cord into a live outlet with proper voltage.
The refrigerator
compartment
lamp is LED interior
lighting, and service should be performed
by
a qualified
technician.
Refer to the Light Bulb
Replacement
section.
REFRIGERATOR
HAS AN UNUSUAL
ODOR
Check if...
Then...
The Air Filter may need to be set to
the MAX setting or replaced.
Set the Air Filter to the MAX setting. If the odor does
not go away within 24 hours, the filter may need to be
replaced.
See the Replacing
the Air Filter section for
replacement
instructions.
ViBRATiON
OR RATTLING
NOISE
,'heck if...
Then...
The refrigerator is not resting solidly on
Floor is weak or uneven or leveling legs need adjusting.
the floor.
See Installation
section on pages 9 and 17.
COMPRESSOR
MOTOR SEEMS TO RUN TOO MUCH
_heckif...
Then...
The refrigerator that was replaced was an older
model.
The room temperature is hotter than normal.
The door is opened often or a large amount of food
has just been added.
Modern refrigerators with more storage space require more
operating time. Even though
this refrigerator
may run more
than your older one it will still use less energy.
The motor will run longer under warm conditions. At normal
room temperatures,
expect your motor to run about 40% to
80% of the time. Under warmer conditions, expect it to run
even more often.
Adding food and opening the door warms the refrigerator.
It is normal for the refrigerator to run longer in order to coo! the
refrigerator back down. See the Food Storage Guide section
on page 22. In order to conserve energy, try to get everything
you need out of the refrigerator at once, keep food organized
so it is easy to find and close the door as soon as the food is
removed.
The refrigerator was recently plugged in and the
The refrigerator will take up to 24 hours to cool completely.
refrigerator control was set correctly.
The refrigerator control is not set correctly for the
See the Adjusting
Control Settings
section on page 21.
surrounding conditions.
The doors are not closed completely.
Push the doors firmly shut. If they will not shut all the way, see
Doors will not close completely below.
The back cover is dirty.
A dirty back cover prevents air transfer and makes the motor
work harder. Clean the back cover. Refer to the Care and
C_eaning section on page 32-33.
4O
Publicidad
