Makita DFL651F Manual De Instrucciones página 9

5. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and the hole becomes visible as illustrated.
And then remove the battery cartridge.
1
► 1 . Adjusting grip
6. Use an optional adjusting grip to adjust the fastening
torque. Insert the pin of the adjusting grip into the
hole on the tool. And then, turn the adjusting grip
clockwise to set a greater fastening torque, and
counterclockwise to set a smaller fastening torque.
7. Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
8. Insert the battery cartridge and be sure that a fastening
torque has been set up by using a fastening torque tester.
9. Rotate the ring on the tool and then tighten the
screw to secure the ring.
10. Attach the protector back to the clutch case.
NOTE:
• Numbers on the fastening torque scale is a guide-
line to set up your desired fastening torque.
Adjusting no-load speed and
revolution angle etc.
2
► 1 . USB cable 2. USB port
After installing application soft in your computer, using USB cable
allows no-load speed and revolution angle adjustment etc. of the tool.
NOTE: Use the makita genuine USB cable to con-
nect your computer to the tool. Refer to the section
"SPECIFICATIONS".
NOTE: For application soft, please contact Makita
sales representative.
ASSEMBLY
•
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
Installing or removing socket
► 1 . Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
Installing hook
Optional accessory
1 The hook is useful to hang the tool.
Install the hook to the holes on the tool body.
► 1 . Hook 2. Hole
9 ENGLISH
CAUTION:
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
2
3
1
1
2