Publicidad
Idiomas disponibles
Idiomas disponibles
Motor
This motor has a manual thermal
overload protector. If the motor
overheats for any reason, the
overload protector will shut off the
motor. The motor must be allowed to
cool down before restarting.
To
restart:
1.
Place the On/Auto/Off
lever in
the Off postion.
3,
Loosen the wing nut on hold
down plate and tilt motor to
allow for easy removal or
installation of the belt.
2.
Allow the motor to cool.
3.
Depress the red reset button on
the motor.
4.
Place the On/Auto/Off
lever in
the On/Auto postion to restart
the motor.
To Replace
Belt
Serious injury or
damage may occur
if parts of the body or loose items
get caught in moving parts. Never
operate the unit with the belt guard
removed. The belt guard should be
removed only when the
compressor is unplugged.
1.
Unplug compressor.
2.
Remove the front of the belt
guard by disengaging
the snaps.
Insert a flat bladed screwdriver at
each snap location and pry the
beltguard apart.
4.
Remove belt.
5.
Replace belt. NOTE: The belt
must be centered over the
grooves on the flywheel and
motor pulley.
6.
Turn the wing nut on the hold
down plate until it makes contact
with the washer, plus one
additional turn.
7.
Replace the belt guard.
21-ENG
D24917
Publicidad
