Publicidad
Idiomas disponibles
Idiomas disponibles
Risk of unsafe
operation.
Overfilling with oil will
cause premature compressor
failure.
Do not overfill.
5.
Replace oil fill plug (A)
and tighten securely.
AIR FILTER = INSPECTION
AND
REPLACEMENT
Hot surfaces.
Risk of burn.
Compressor
heads are exposed
when filter cover is removed.
Allow compressor
to cool prior to
servicing.
Keep the air filter
clean at all times. Do
not operate the air compressor with
the air filter removed.
A dirty air filter will not allow the com-
pressor to operate at full capacity.
Keep the air filter clean at all times.
1.
Remove
the air filter
cover.
2.
Remove
the air filter
from filter
cover.
IMPORTANT:
Do not oper-
ate the compressor with the air filter
removed.
3.
Place new air filter into filter cover.
Refer to the Repair Parts for the
correct part number.
4.
Replace air filter cover and lock
into place.
BELT = REPLACEMENT
Risk of personal
injury. Serious injury or damage
may occur if parts of the body or
loose items get caught in moving
parts. Never operate the outfit
with the belt guard removed.
The
belt guard should
be removed only
when the air compressor
power is
disconnected.
1.
Turn air compressor
off, lock out
the power supply, and relieve all
air pressure from the air tank.
2.
Remove the front of the belt
guard by disengaging the snaps.
Insert a flat bladed screwdriver
at each snap location and
pry the beltguard apart.
3.
Loosen the wing nut on hold
down plate and tilt motor
to allow for easy removal or
installation of the belt.
4.
Remove belt.
Risk of moving parts.
Use caution when rolling belt onto
flywheel,
fingers can get caught
between
the belt and flywheel.
5.
Replace belt. NOTE: The
belt must be centered over
the grooves on the flywheel
and motor pulley.
6.
Turn the wing nut on the hold
down plate until it makes
contact with the washer,
plus one additional turn.
7.
Replace the belt guard.
N001248
18-ENG
Publicidad
