Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
CAUSE
Motor will not
Loose electrical
run (continued)
connections.
Possible defective motor
or starting capacitor.
Paint spray on internal
motor parts.
Safety Valve on
pump "pops"
out
Knocking Noise
Pressure release valve on
3ressure switch has not
Jnloaded head pressure.
Fuse blown, circuit breaker
tripped.
Pressure switch, check
valve, or pump could be in
need of servicing.
Possible defect in safety
valve.
Defective check valve.
Loose pulley.
Loose flywheel.
Compressor mounting
screws loose.
Loose belt.
Carbon build-up in pump.
Belt to tight.
CORRECTION
Check wiring connection inside
pressure switch and terminal box
area.
Have checked by a Trained Service
Technician.
Have checked by a Trained Service
Technician. Do not operate the
compressor in the paint spray area.
See flammable vapor warning.
Bleed the line by pushing the lever
on the pressure switch to the "Off"
position; if the valve does not open,
replace switch.
Check fuse box for blown fuse
and replace as necessary. Reset
circuit breaker. Do not use a fuse
or circuit breaker with higher
rating than that specified for your
particular branch circuit.
Check for proper fuse. You
should use a time delay fuse.
3.
Check for low voltage conditions
and/or proper extension cord.
4.
Disconnect the other electrical
appliances from circuit or operate
the compressor on its own
branch circuit.
Have checked by a Trained Service
Technician.
Operate safety valve manually by
pulling on ring. If valve still leaks, it
should be replaced.
Remove and clean, or replace.
Tighten pulleyset screw.
Tighten flywheel screw, see Parts
manual for torque specifications.
Tighten mounting screws,see Parts
manual for torque specifications.
Loosen wingnut and then tighten
wingnut until it contacts the washer,
plus one turn.
Have checked by a Trained Service
Technician.
Loosen wingnut and then tighten
wingnut until it contacts the washer,
plus one turn.
23-ENG
N001248
Publicidad
