WARNING
Failure to follow these warnings and instructions could result in
serious injury or death.
DO BE cautious that the rigid items and plastic parts of an
enhanced child restraint system shall be located and installed so
that they are not liable to become trapped by a movable seat or in
a door of the vehicle during everyday use of the vehicle.
DO NOT use the rearward facing enhanced child restraint
systems in seating positions where there is an active frontal
airbag installed.
Any support-leg should be in contact with the vehicle floor. Any
straps restraining the child should be adjusted to the child's body,
and the straps should not be twisted.
To use this enhanced child restraint according to UN Regulation
No. 129, your child must meet the following requirements:
Child height 40cm-83cm/Child weight≤13kg.
This enhanced child restraint should be replaced when it has
been subject to violent stresses in an accident.
DO NOT use any load bearing contact points other than those
described in the instructions and marked on the enhanced child
restraint.
Consider the danger of making any alterations or additions to
the device without approval of the Type Approval Authority, and
the danger of not following closely the installation instructions
provided by the child restraint manufacturer.
Please keep this enhanced child restraint away from sunlight,
otherwise it may be too hot for child's skin. Always touch the
enhanced child restraint before placing child in it.
DO NOT leave your baby unattended in the child restraint system.
Any luggage or other objects liable to cause injuries in the event
of a collision shall be properly secured.
The Enhanced Child Restraint System shall not be used without
the textile covers.
The Enhanced Child Restraint System cover should not be
replaced with any other than the ones recommended by the
manufacturer, because the cover constitutes an integral part of
the restraint performance.
Please also pay attention to the instructions and warnings in the
vehicle manufacturer's handbook.
DO NOT use the rearward facing enhanced child restraint
systems in seating positions where there is an active frontal
airbag installed. Death or serious injury may occur. Please
reference vehicle owner's manual for more information.
5
PIPA lite Instructions
Parts List
Make sure all parts are available before assembly.
If any part is missing, please contact Nuna. No tools are required for
assembly.
1
Seat Pad
2
Infant insert
3
Buckle and Crotch Pad
4
Harness Adjustment Button
5
Harness Adjustment Strap
6
Instruction Manual Storage
7
Handle Adjustment Button
8
Stroller Release Button*
9
Shoulder Harness Pads
1
2
3
4
5
10
2
* only used with infant child restraint adapters
10 Head Support
11
Handle
12 Canopy
13 Canopy Release Button
14 Stroller Release Button
15 Base Attachment Bar
16 Harness Straps
17 Base Attachment Bar
11
10
9
12
8
7
13
6
14
15
16
17
6
PIPA lite Instructions