Bosch HBE5451UC Manual De Instalación página 5

Before You Begin
Tools and Parts Needed
o Philips head screwdriver
o 1/8" drill bit and drill
o Measuring tape
Parts Included
Built-in oven
Power Requirements
The outlet must be properly grounded in accordance with
all applicable codes.
Preparing the units
o Safe use of this appliance can only be guaranteed if it
has been installed professionally in accordance with
these installation instructions. The installer shall be
liable for damages incurred as a result of incorrect
installation.
Fitted units must be heat-resistant up to 195°F (90°C),
and adjacent unit fronts up to 160°F (70°C).
Cut-out work on the units and worktop should be
performed before fitting the appliances. Remove any
shavings as they may impair the function of the
electrical components.
Removing Packaging
NOTICE: To prevent damage to your floor keep the unit
in its packaging base until ready to be placed in the
cabinet opening. Do not slide the unit across the flooring.
Different models use different packaging materials.
Actual brackets may look differently. Bracket remains in
packaging base.
1. Cut straps on outside of box.
2. Remove cardboard box.
3. Remove all top and side cardboard and Styrofoam
braces.
4. Place oven in front of cabinets where it is to be
installed.