Mobicool S25 DC/AC Instrucciones De Uso página 6

Operation S25 DC/AC, X25 DC/AC, X30 DC/AC
5.2 Using the cooler
Caution!
S25: Lift the cooler by the handle, not by the shoulder strap.
Otherwise you risk spillage.
If the handle is folded back of if the cooler is being carried, the lid
is locked. You can only open the lid when the handle is folded for-
wards.
Note
Like every cooling device, your cooler must be properly ventilated
so that any heat created can dissipate. Otherwise proper function-
ing cannot be ensured.
» Place the cooler on a firm base.
> Connect the 12 V connection cable (FX 1, page 4) into the cigarette light-
er socket or a 12 V socket in the vehicle
or
» Plug the 220-240 V connection cable (EX 2, page 4) into the AC voltage
socket and connect it to the 220-240 V AC mains supply.
Switch off the battery monitor (EJ 2, page 4, ABS accessory) (OFF
position).
> Only on versions with the additional heating feature: Push the switch
(El 3, page 4) on the control panel to "COLD" or "HOT" to switch on the
cooler.
Note
Close the box tightly by pushing down the lid.
/ The indicators on the control pue show you the ëss mode:
Operating display Operating mode
Green (El 1, page 4) Cooling
Red (EJ 2, page 4) Heating
/ The cooler starts cooling/heating the interior
10
S25 DC/AC, X25 DC/AC, X30 DC/AC EN
Caution!
A Ensure that the objects placed in the cooler are suitable for cooling
to the selected temperature.
» If you wish to switch the cooler off:
— Slide the switch (EI 3, page 4) to the "OFF" position (only with the
heating accessory)
— Pull out the connection cable
5.3 Using the battery monitor
(Only on versions with the additional ABS feature)
Caution!
If you operate your cooler with the 220-240 V AC mains supply,
switch off the battery monit
> Push the switch (E 2, page 4) on the Deeg Së to "ON" to switch
on the battery monitor.
v The red LED (EJ 1, page 4) on the operating panel displays the status of
the battery monitor:
Operating display Operating mode
LED glows The switch-on voltage (13.1 V + 0.2 V) is present
and the cooler is in operation.
LED flashes The switch-off voltage (11.7 V + 0.2 V) has been
reached and the battery monitor has switched off
the cooler.
» Push the switch (EJ 2, page 4) on the operating panel to "OFF" to switch
off the battery monitor.
5.4 Changing the lid
(Only on versions with the additional insulating lid feature)
As an alternative to the unit lid, you can use an insulating lid when transport-
ing the cooler.
» Fold the handle of the cooler forwards.
> Open the lid until it is vertical and then remove it by lifting it upwards.
> Place the insulating lid with the guide lugs into the slots on the cooler.
11