Descargar Imprimir esta página

MTD 601 Manual Del Operador página 20

Ocultar thumbs Ver también para 601:

Publicidad

Idiomas disponibles

Idiomas disponibles

Jump Starting
_
WARNING:
When removing or installing
the
battery,
follow
these
instructions
to
prevent the screwdriver from shorting against
the frame.
IMPORTANT: Never jump your tractor's dead battery
with the battery of a running vehicle.
Connect end of one jumper cable to the positive
terminal of the good battery, then the other end to
the positive terminal of the dead battery.
Connect the other jumper cable to the negative
terminal of the good battery, then to the frame of
the unit with the dead battery.
_,
WARNING:
Failure to use this procedure
could cause sparking, and the gas in either
battery could explode.
Cleaning
Clean the battery by removing it from the tractor and
washing with a baking soda and water solution. If
necessary, scrape the battery terminals with a wire
brush to remove deposits. Coat terminals and exposed
wiring with grease or petroleum jelly to prevent
corrosion.
Battery Failures
Some common causes for battery failure are:
• incorrect initial activation
• undercharging
• overcharging
• corroded connections
• freezing
These failures are NOT covered by your tractor's
warranty.
Cutting Blades
WARNING:
Be sure to shut the engine off,
remove ignition key, disconnect the spark plug
wire(s) and ground
against the engine to
prevent unintended starting before removing
the
cutting
blade(s)
for
sharpening
or
replacement.
Protect your hands by using
heavy gloves or a rag to grasp the cutting
blade.
WARNING:
Periodically inspect the blade
spindles for cracks or damage, especially
if
you
strike
a
foreign
object.
Replace
immediately if damaged.
The blades may be removed as follows.
Remove the deck from beneath the tractor, (refer to
Cutting DeckRemoval on page 19) then gently flip the
deck over to expose its underside.
Place a block of wood between the center deck
housing baffle and the cutting blade to act as a
stabilizer. See Figure 16.
Use a 15/16" wrench to remove the hex flange nut
that secures the blade to the spindle assembly. See
Figure 16.
Hex Flange Nut
Figure 16
To properly sharpen the cutting blades, remove
equal amounts of metal from both ends of the
blades along the cutting edges, parallel to the
trailing edge, at a 25 ° to 30 ° angle. See Figure 17.
IMPORTANT: If the cutting edge of the blade has already
been sharpened to within 5/8" of the wind wing radius,
or if any metal separation is present, replace the blades
with new ones. See Figure 17.
Blade Separation
/
Worn Blade Edge
Wind Wing
Sharpen
Edge Evenly
Figure 17
It is important that each cutting blade edge be ground
equally to maintain proper blade balance.
A poorly balanced blade will cause excessive vibration
and may cause damage to the tractor and result in
personal injury. The blade can be tested by balancing it
on a round shaft screwdriver. Grind metal from the
heavy side until it balances evenly.
20

Publicidad

loading