Descargar Imprimir esta página

MTD 601 Manual Del Operador página 21

Ocultar thumbs Ver también para 601:

Publicidad

Idiomas disponibles

Idiomas disponibles

When replacing the blade, be sure to install the blade
with the side of the blade marked "Bottom" (or with a
part number stamped in it) facing the ground when the
mower is in the operating position.
IMPORTANT: Use a torque wrench to tighten the blade
spindle hex flange nut to between 70 foot-pounds and
90 foot-po unds.
Fuses
Two fuses are installed in your tractor's wiring harness
to protect the tractor's electrical system from damage
caused by excessive amperage.
If the electrical system does not function, or your
tractor's engine will not crank, first check to be certain
that the fuse has not blown.
One can be found under the hood mounted behind the
top of the dash panel on the support bar. The other can
be found under the seat mounted to the inside of the
tractor frame next to the battery tray.
_,
ARNING:
Always
use a fuse with the
same amperage capacity for replacement.
Changing theDeckBelt& PTOBelt
WARNING:
Be sure to shut the engine off,
remove
ignition
key, disconnect
the spark
plug wire(s) and ground against the engine to
prevent unintended
starting before removing
the belt(s).
WARNING:
Avoid
the
possibility
of
a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the deck belt and PTO belt on
your tractor, proceed as follows:
Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
Remove the belt guards by removing the self-
tapping screws that fasten them to the deck.
G rasp the rearmost portion of the PTO idler bracket
and pivot it toward the discharge chute to relieve
tension on the PTO belt.
Remove the PTO belt from around the engine
pulley and the PTO idler pulley(s).
Grasp the deck idler pulley and pivot it toward the
left side of the deck to relieve tension on the deck
belt.
Remove the deck belt from around all pulleys,
including the deck idler pulley(s).
Route the new belt(s) (deck belt first) as shown in
Figu re 18.
Remount the belt guards removed earlier.
Engine Pulley
PTO Idler Bracket
(mounted on tractor)
/
Oeck be,t IBottom)
[]
PTO belt (Top)
)eck Idler
Right Hand Pulley
belt guard)
Left Hand
_
Double Pulley
Center Pulley
NOTE: Front Deck wheels are NOT standard equipment.
Figure
18
21

Publicidad

loading