Publicidad
Idiomas disponibles
Idiomas disponibles
nstallat
WARNING!
• Use a heavy metal vent.
- Do not use plastic or thin foil duct.
. Failure to follow these instructions
can
result in death or fire.
• Clean old ducts before installing this dryer
improper taping and unstable installation of vent
will _use und_irable
d_ing performance,
In Mdifion to the following warnings, please refer to
manual section on Exhaust Requirements aM
Maintenance, page 15.
IMPORTANT:
To reduce the risk of fire, combustion,
and gas accumulation, the dryer must be vented to the
ou:tdoo_. Please follow the instructions (arid all
others in this manual) very carefully.
÷
+
• Do not use Plastic or thin loil duct.
° Use 4" (10.2 cm) diameter rigid or Semi-rigid
metN duct (note: venting materials am not
supplied with the dryer, and you should obtain the
venting rnaterials necessary for proFmr installation)
° Positkm the Dryer so that the exhaust duct run is
as short as possible.
• Clean oM ducts bejore installing this dryer
. The male end of each section of exhaust duct must
point
away from the dryer
• Use as li:w elbow joints as possible.
o [lse duct ta_ on all duct joints
° Insulate ductwoN
that runs through unheamd
areas in order m reduce condensation
and lint
build-up on piw walls.
Du6ng ' !mns_on
s!de_p canco_._ _t _gid!y.
!f lhat iss?, _sh and _ it !o t'neF_ _ prevent
To change duct direction, follow these ste_,
, Remove Duct Conn_tor.
Duct Connector
2. Remove the right (or left) Side Cap by (4 driver,
Side Cap
/
3, Assemble the Duct Connector to the hole and
dose the back hole by the Side Cap.
Side Cap
• PLEASE BE AWARE THAT FAILURE
TO
EXHAUST THE DRYER CORRECTLY
WILL
VOID THE DRYER'S WARRANTY.
Publicidad
