Publicidad
Idiomas disponibles
Idiomas disponibles
nstal
Instructions
Following are several warnings mid inslructions
concerning ma_ng the electrical connectkm fi_r electric
dryers. More detailed intk_rlnatkm concerning the
electrical connection is provided in tile manual secli(m
entitled Electrical Requirements liar Electric Drvel:
It is imporlant _hat you thoroughly review that section
_d the remainder of this manual, b_fore taking any
s_eps to install or use riffs dryer.
1. Use only a new U.L. listed No. 10 (copper wire only)
three c_mductor power supply cord kit rated 2_)
Volts (minimum) 30 Amperes and labmled as suitable
for use in a clothes dryer.
2. Fourowire cord is required _i_rmanufactured (mobile)
home installations and where local c(_es do not
allow grounding of this appliance thrcmgh neutral.
3, Electrical Plug Cormections.
4. For addifi(mal inslruction on connecting the dryer to
an eleclrical [_)wer source, please refi_r m this
manual's section on Electrical Requirements and
Electric Dryer.
WARNING!
- Use a new UL approved 30 amp power supply
cord or 10 gauge solid copper wire
• Use a UL approved strain relieL
, Disconnect power before making electrical
connections.
- Connect neutral wire(white or center wire) to
center terminal
- Ground wire(green or bare ware) must be
connected to green ground connector.
- Securely tighten all electricN connections
- See installation instructions for complete
nstruct_ons,
- Failure to do so can result in fire or electrical
shock.
Prior to the first use of riffs appliance, use all-
purpose cleanfl_g products or a solution of detergent
and water, with damp clotll to remove from the
inside of the duer drungdrying
compamnent
any
dust or dirt that may have accunmlated
inside the
dryer. Plug-in your dryer after reviewing the
lk_llowing parts on your dryer's Electrical
Requirements.
eleva_on becau_ A,G.A_rtifi_
_iS drier wiR not
haveany problem wi_ the BoT.U rating at this aRRude.
If your houseis above 10,_0 feet, you aret_uired
raSng i_icated on the model/serial raUngplate,
Close the d_r to the dryer drum/drsdng
compartment and, after completing all steps in this
manual for pro_r installation of this dryer, start the
dryer on a heat setting, as described more fully in
the o_rating
instructions that accompany the dryer.
The exhaust air or the exhaust pipe should be warm
after the dryer has been o_rating
for three minutes.
Publicidad
