Publicidad
ENGLISH
Please note:
-
Before serving water, wait until it stops boiling.
-
Do not open the lid when serving.
4. CLEANING AND MAINTENANCE
-
Always unplug the kettle from the mains supply before cleaning it.
-
The exterior of the kettle can be cleaned with a slightly dampened cloth. Do not use powder
detergent or cleaning agents, as these could damage the product's surface.
-
Do not immerse the product, its power cord, plug or power outlet in water.
-
If you observe mineral deposits such as limescale, we recommend following the steps
below:
Pour half a litre of 8 % white vinegar into the kettle and let it sit for 1 hour.
1.
2.
Pour the vinegar out and rinse the kettle with water 4 or 5 times.
3.
Pour half a litre of water to be boiled and 25 ml of lemon juice into the kettle.
4.
Let sit for 15 minutes and rinse again 4 or 5 times with clean water.
5. TROUBLESHOOTING
Problem
Possible causes and solutions
It turns off
There might be scale inside the kettle. Clean and descale.
before boiling.
Inadequate amount of water in the kettle or empty kettle. In order to
reset the device again pour cold water into the kettle and wait 2 minutes;
then you can restart the kettle.
The kettle does
Make sure the plug is properly inserted into the socket and that the
not work.
socket is working.
If the power cord is damaged, contact the Technical Support Service of
Cecotec.
Run the kettle without water, the protection system of the device cuts
off the power supply.
The water
This problem usually occurs when the kettle is used for the first time. In
in the kettle
order to solve this problem, proceed in accordance with the cleaning and
has a strange
maintenance section.
smell.
If the problem persists, fill the kettle with water up to the maximum
level, add two tablespoons of baking soda, and after boiling empty the
kettle.
32
THERMOSENSE 400 BLACK WOODY/WHITE WOODY
Inside the
When using hard water, calcium, bicarbonate, and magnesium
kettle water is
carbonate can accumulate. Decalcify the kettle regularly.
dirty and you
can see the
scale.
6. TECHNICAL SPECIFICATIONS
Model: ThermoSense 400 Black Woody/ ThermoSense 400 White Woody/ ThermoSense
400 Black Woody X/ ThermoSense 400 Black Woody M/ ThermoSense 400 Black Woody S/
ThermoSense 400 Black Woody T/ ThermoSense 400 White Woody X/ ThermoSense 400
White Woody M/ ThermoSense 400 White Woody S/ ThermoSense 400 White Woody T
Product reference: 01479/01480/01489/01490/01491/01492/01493/01494/01495/01496
Capacity: 1.7L
Rated power: 2500-3000 W
Voltage and frequency: 220-240 V ~ 50/60 Hz
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should dispose
of the batteries/accumulators and take them to a collection point designated
by the local authorities.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
8. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
time of delivery of the product under the terms, conditions, and deadlines established by the
applicable regulations.
It is recommended that repairs be carried out by qualified personnel.
If at any moment you detect any problem with your product or have any doubt, do not hesitate
to contact the official Cecotec Technical Support Service at +34 963 210 728.
ENGLISH
THERMOSENSE 400 BLACK WOODY/WHITE WOODY
33
Publicidad
