GB
INSTRUCTION MANUAL OF UNIVERSAL LOADING CHARGER LOG
CAREFULLY READ THE FOLLOWING INSTRUCTIONS BEFORE CONNECTING
THE DEVICE TO THE POWER SUPPLY AND / OR THE BATTERY.
IS APPROPRIATE FOR THE BATTERY CONNECTED TO IT.
Read these instructions carefully to make the best use of your device and avoid future
problems. Polar s.r.l. strongly recommend that you carefully follow all the information
and tips reported below for a safe use of your device.
The correct use of your device will increase its operating life and maximize its efficiency.
If you have any feedback for us, your suggestions will be highly appreciated to improve
the quality of our service.
Thank you for your trust and for choosing our products.
For more information, technical details, brochures or illustrative material please contact
us or visit our website: www.polar-electronics.com.
Make sure that the power and charging plugs are installed.
If not, contact a specialized technician to install the connectors properly sized
for the device and the power supply.
Make sure that the DC and AC charging cables are in perfect condition before proceeding
with the installation.
Make sure that the main socket to which the device will be connected is properly grunded
and protected by adequate safety measures.
Make sure that the device is suitable for the battery by checking the technical data shown
on the charger.
Make sure that the device is positioned in a place suitable for its purpose.
Avoid placing the device in areas with sparks and / or flames as the battery generates
explosive gases during charging. The environment in which the charger is installed must
have the minimum requirements to guarantee operator safety and the perfect functioning
of the appliance, therefore it must be: dry, ventilated and not dusty.
In relation to its degree of protection, the charger must not be exposed to splashes
of water or rain, dusty or humid environments.
The battery charger must not be installed in places considered dangerous in relation
to the processes present, such wood processing waste and other flammable materials.
It is recommended to fix the battery charger to a wall using its appropriate holes
and to make sure the air inlet and outlet openings are not obstructed, in order to favor
correct forced cooling.
For the same reason, do not accumulate materials of any kind in its proximity,
do not place objects or containers for liquids of any kind on the battery charger.
ALSO, MAKE SURE THAT THE SIZE OF THE DEVICE
PREPARATION
RECOMMENDATIONS
16.