Beper 90.513 Manual De Instrucciones página 10

Milk frother Use instructions
Switch functions
6- Stir hot, e.g., sauces, milk or chocolate drinks
Heat or froth milk or hot chocolate
7- Stir and froth cold
Frothing milk
• Install attachment 2a.
• Pour in the milk. The pitcher holds to 300 ml of liquid.
Attention:
Observe the "Full" mark
Note:
• For best results, use a full batch of milk with 3.5% fat content.
• Foam doesn't form as well with 1.5%, soy or lactose free milk.
• Put on the lid.
• Place the pitcher on the console.
• Press the button 6.
Note:
• The buttons light up to show their functions.
• The process lasts 90 to 240 seconds and ends automatically.
• If you want to end the process sooner, press the button again or remove the pitcher from the con-
sole.
Heating milk or cocoa
Use attachment 2b.
Attention:
• Add the chocolate powder after the milk; otherwise the mixing attachment will clog.
• Stay within the full mark, or the drink may overflow.
Proceed as described in "Frothing milk".
Observe the "Full" mark
Heating sauces
This milk frother can also heat sauces. Sauces are brought to a higher temperature than milk or hot
chocolate.
Use attachment 2b and proceed as described under "Frothing milk".
• To heat the sauce, press the button 6.
• Once you have heated liquids with the milk frother, the appliance takes about 3 minutes to cool
down again.
• You can shorten this process by filling the pitcher with cold water and placing it on the console.
• You can select the "Stir cold" function at any time.
Stirring or frothing cold
With the milk frother, you can also separately stir or froth liquids. When you do this, the liquids are
not heated.
Use attachment 2a or 2b and proceed as described under "Frothing milk".
• Press the button7.
; otherwise the milk will foam over.
; otherwise the milk will foam over.
10