Descargar Imprimir esta página

Craftsman 919.167370 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking
1.
Remove unit from carton and
discard all packaging.
HOW TO SET UP YOUR
UNIT
IMPORTANT: The outlet being used
Location
of the Air Compressor
Locate the air compressor
in a
clean, dry and well ventilated area.
The air compressor
should be
located at least 12" away from the
wall or other obstructions
that will
interfere with the flow of air. The
air compressor
pump and shroud
are designed to allow for proper
cooling. The ventilation openings
on the compressor
are necessary
to maintain proper operating
temperature.
Do not place rags or
other containers on or near these
openings.
GROUNDING
INSTRUCTIONS
_Risk
of Electrical
Shock.
in the
event of a short circuit,
grounding
reduces
the risk of shock by
providing
an escape wire for
the electric
current.
This air
compressor
must be properly
grounded.
The portable air compressor
is
equipped with a cord having a
grounding wire with an appropriate
grounding plug (see following
illustrations).
The plug must be used
with an outlet that has been installed
and grounded in accordance
with all
local codes and ordinances.
1.
The cord set and plug with this
unit contains a grounding pin.
This plug MUST be used with a
grounded outlet.
must be installed and grounded in
accordance
with all local codes and
ordinances.
Make sure the outlet being used
has the same configuration
as the grounded plug. DO
NOT USE AN ADAPTER. See
illustration.
Inspect the plug and cord before
each use. Do not use if there are
signs of damage.
If these grounding instructions
are not completely
understood,
or if in doubt as to whether
the compressor is properly
grounded, have the installation
checked by a qualified
electrician.
Risk of Electrical
_
Shock.
improper
grounding
can result in electrical
shock.
Do not modify the plug provided,
if
it does not fit the available
outlet,
a correct
outlet should
be installed
by a qualified
electrician.
Repairs to the cord set or plug
MUST be made by a qualified
electrician.
N000317
10-ENG

Publicidad

loading