•Disposal
The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you
that in the European Union, all electrical and electronic products, batteries, and
accumulators (rechargeable batteries) must be taken to designated collection
locations at the end of their working life. Do not dispose of these products as
unsorted municipal waste. Dispose of them according to the laws in your area.
IC Requirements:
Licence-exempt radio apparatus
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
F Exposure Information (if appropriate)
•DO NOT operate the radio without a proper antenna attached, as this may damage the
radio and may also cause you to exceed RF exposure limits. A proper antenna is the
antenna supplied with this radio by the manufacturer or an antenna specifically authorized by
the manufacturer for use with this radio, and the antenna gain shall not exceed the specified
gain by the manufacturer declared.
•DO NOT transmit for more than 50% of total radio use time, more than 50% of the time can
cause RF exposure compliance requirements to be exceeded.
•During transmissions, your radio generates RF energy that can possibly cause interference
with other devices or systems. To avoid such interference, turn off the radio in areas where
signs are posted to do so.
20