Publicidad
Idiomas disponibles
Idiomas disponibles
GARDEN HOSE INSTALLATION
1.
Thread female end of the garden hose
through the hose alignment guide and then
through the inside of the left side of the
hose reel. Make sure to insert through the
largest hole.
2.
Attach to the brass fitting and ensure a
snug fit.
3.
Place the hose clip around the hose, with
the flat side facing the hose reel. Press
the two ends of the hose clip together
and align the nut over the M6 x 20 Screw.
Secure by holding the hose in place and
tightening the M6 x 20 Screw with the 4
mm hex key.
Hardware Used
M6 x 20 Screw
4 mm Hex Key
1
2
3
x 1
10
Publicidad
