Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.2.1. WIRE WELDING PROCESS. (MIG/MAG)
5.2.2. WELDING PROCESS WITH SELF-SHIELDED WIRE.
5.3. WELDING PROCESS WITH ELECTRODE (MMA).
In this welding process, selector
the current in amperes and
VRD
. (This device reduces the no-load voltage (U₀) to avoid high-risk welding accidents).
Connect the electrode holder to the negative terminal and the ground clamp to the positive.
A
does not work. Selector
D
the voltage in volts. You can choose whether or not to activate the
42
In this welding process, with solid wire, you
must use a protective GAS. Locate the
location of the gas inlet on the rear panel of
the machine.
Connect the torch power to the positive
terminal and the work clamp to the
negative terminal.
When installing the wire always remove the
nozzle and the contact tip of the torch,
after passing the wire put them back.
In this welding process, with self-shielded
wire, it is not necessary to use a protective
GAS.
Connect the torch power to the negative
terminal and the work clamp to the positive
terminal.
When installing the wire always remove the
nozzle and the contact tip of the torch,
after passing the wire put them back.
B
adjusts the welding current, displaying
C
Publicidad
