Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
C-CP-D-SQ-S13L Series
MOUNTING USING ½" PLUGS ON THE SIDE
1.
Remove the four screws attaching the lens diffuser to the fixture
and set the screws and lens aside.
2.
Remove the screws attaching the reflector to the housing and set
aside.
3.
Remove 1/2" plug from direction you intend to feed conduit. Teflon
tape should be used on conduit threads to prevent water entry.
NOTE: The (2) screws on either side of the 1/2" plug should not
be removed during installation. See Figure 2.
4.
Fixture is best mounted by drilling holes in the four corners of the
housing. Holes should be drilled from the outside of the casting
through the centers of each of the (4) circular ribbed mounting
supports in the corners of the housing. Make sure metal chips are
cleaned from inside housing after drilling. Fixture is to be secured
to the mounting surface using mounting hardware (supplied
by others) appropriate for the mounting surface. A high grade
caulking material, such as silicone rubber, should be used around
all the holes to ensure a watertight enclosure.
5.
Complete the wiring to the incoming power and ground (refer to
"Fixture Wiring" section).
6.
Position the wattage selection switch on the inside of the housing
to the desired setting. See Figure 1.
NOTE: Factory setting is 100%.
7.
Replace the reflector and lens diffuser. Make sure no wires are
pinched when replacing parts. Gradually tighten lens screws in an
"X" pattern. Do not overtighten lens screws to prevent damage to
lens.
FIGURE 2
Do NOT Remove These Screws During
Installation
http://lighting.cree.com/warranty
Document:
LPN00473X0002A0_A
Created By:
TMT
ELECTRICAL CONNECTIONS
Fixture is equipped with universal volt driver 120-277V
(ie. 120V, 208V, 240V or 277V)
PHASE TO NEUTRAL WIRING 120/277V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply common to fixture neutral (white) lead.
3. Connect supply Vin to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no wires
are pinched.
PHASE TO PHASE WIRING 208/240V
1. Connect supply ground to fixture ground (green) lead.
2. Connect supply L1 (Hot) to fixture neutral (white) lead.
3. Connect supply L2 (Hot) to fixture hot (black) lead.
Tuck all wires carefully into wiring chamber ensuring that no wires
.
are pinched.
FCC NOTICE
CAUTION: Changes or modifications not expressly approved could
void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
CAN ICES-005 (A)/NMB-005 (A)
|
1-800-236-6800
Date:
5-17-2023
Publicidad
