Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION - WALL MOUNTING
1.
Mark and drill desired location on mounting surface of the wall. Mounting
brackets will come pre-installed. Luminaire is provided with three ¾" NPT
conduit entries and two plugs shipped with the luminaire, but not installed
(Figure 1). Plug the conduit entries not being used. To prevent galling and to
ensure water tightness, lubricate conduit plugs with Eaton's Crouse-Hinds series
HTL lubricant before installing, and secure wrench-tight with at least five (5) full
threads engaged (42-52 ft.-lb. for 3/4" plugs).
2.
Secure luminaire with mounting brackets to surface using 1/4" screws or lag bolts.
Mounting bracket
Side conduit entry
Hex screws to fix
mounting brackets to
IF 1966 • 08/23
2X 2.60
2X MTG 1.54
Copyright
2023, Eaton's Crouse-Hinds Division
©
1.84
2X 3.48
2X MTG 11.40
Figure 1
Back conduit entry
Mounting bracket
Hex screws to fix
mounting brackets to
Side conduit entry
.15
Secondary
retention
hook
Page 4
Publicidad
