Publicidad
Idiomas disponibles
Idiomas disponibles
•
,Secure brackets into tool rest bases using lockinghandles.
INSTALL
LEVER, HANDLES
AND FINE
ADJUSTMENT
SCREW
Refer to Figure 6.
•
Insert bushingsinto lever. Slide 8 x 20mm sockethead bolts
through bushings.Thread bolts into carriage and block.
• Thread the four handles with knob intothe hub.
Hex Nut
Fine Adj
Screw
Carriage
Lever w itch
i
Grip
L
,-<_Socket
Head Bolt
Figure6 - Install Leverand Handles
• Thread fine adjustment screw with hex nut into block.
INSTALL CUTTING
TOOL AND SAFETY
SHIELD
Refer to Figure 7.
Insert cuttingtool into tool holder and use 8 x 10mm set
screw to secure in position.Cutting tool shouldextend out
approximately1W' from holder.
Slide safety shield onto tool holder.Secure in positionwith
pan head screw.
Check height of cuttingtool Cuffing toot shouldbe approxi-
mately ',_" above the spindle centedine. Insert canters into
headstock and tailstockspindlesand check tool at each
spindle.If necessary,adjust height by removing spacers
beneath brackets.
Pan Head Screw--->T
Safety i
ToSoo:t
HSo_rd'; _ '-_ hield "_k _
'_r'_" C utting Tool
Figure 7 - Install CuttingTool and Safety Shield
INSTALL GUIDE
PIN AND FOLLOWER
ASSEMBLY
Refer to Figure 8.
Remove protectivepaper from cover.
Insert guide pin into slot of yoke. Secure in positionwith
washer and hex nut.
• Slide follower assembly onto guide pin.Secure in position
with socket head bolt.
C_
_
Scre_
Yoke
"_'N3uide
Pin
Follower Assembly
_,,_
.L "_-Washer
Socket Head Bolt _
_'_r-_
",_
"_,_--
Hex Nut
Figure 8 - Install Guide Pin and FollowerAssembly
INSTALL
PATTERN SUPPORT
Refer to Figure 9.
• Thread pattern bolt and hex nut into pattern support.
Insert 8 x 60mm socket head bolt and fiat washer into slotof
pattern support and bracket and secure in position with
bracket nut.
Bracket Nut
_Bracket
Support
Figure 9 - Install Pattern Support
ATTACH CARRIAGE
SUPPORT TO CARRIAGE
(MODEL
24951)
Refer to Figure 10.
• Loosen set screw and position carriage support against
carriage.
•
Secure carriage supportto carriage with 8 x 25mm socket
head bolts and fiat washers.
•
Secure carriage supportto guide with set screw.
Washer
Socket Head Bolt
Carriage Support_
_,_
Bed
Figure 10 - Attach Carriage Support to Carriage (Model 24951)
5
Publicidad
