Trumpf TruTool C 160 Traduccion Del Manual De Instrucciones Originale página 12

EN
1.3 Symbols
The following symbols are important for
reading and understanding the operator's
manual. The correct interpretation of the
symbols helps to operate the power tool
properly and safely.
Sym-
Description
bols
Type of slitting shears, e.g.
C 160
TruTool C 160 (2A5)
(2A5)
Power tool with rechargeable bat-
tery
Power tool with power cable
Power tool with speed controller
Power tool with chip clipper
Lubrication
Inspection
Loosening/tightening Torx-head
screw
Check charge of rechargeable bat-
tery
Read operator's manual
Disposal/recycling of old devices
and batteries
Li-ion
12 Translation of the original operator's manual
1.4 Warnings in this document
Warnings warn about dangers that can occur
when handling the power tool. They come in
four danger levels that can be distinguished
by the signal word:
Signal Meaning
word
DANGER Indicates a danger with high
risk, which can cause death or
severe injuries if it is not
avoided.
WARNING Indicates a danger with
medium risk, which can cause
severe injuries if it is not
avoided.
CAUTON Indicates a danger with low
risk, which can cause minor or
moderate injuries if it is not
avoided.
ATTEN- Indicates a danger that can
TION cause property damage.
1.5 Proper use
TRUMPF slitting shears are hand-guided
power tools for the following applications:
– Slitting plate-shaped workpieces made
of steel, aluminum, plastic, etc.
– Slitting straight or curved outer edges
and making interior cut-outs
– Slitting after marking
C 160 C 250 C 250
(2B5) (3B5) (2B1)
shears also offer the opportunity to cut off
the chip that arises within the workpiece dur-
ing processing.
These TRUMPF slitting