Publicidad
Idiomas disponibles
Idiomas disponibles
Inspections must first be carried out after exceptional events (e.g. storm, hail, high snow load, etc.)
•
but also regularly. During these inspections, it should be verified whether the components are safe,
intact and clean.
ONLY clean modules that have been cooled.
•
Do NOT clean the modules with water if there is a risk of freezing.
•
•
Remove dirt with warm water or a soft cloth. Do NOT scratch dirt. Remove snow and ice without
force
Leave the substructure free of dirt and debris.
•
Do NOT use abrasive detergents; surfactants, scrapers or cleaning equipment with pressurized
•
water. Do NOT use micro-polar wool or cotton cloths.
Assembly Warnings
Before installation, please check all the components of the solar kit to ensure that there is no
•
transportation or handling damage, which may affect the insulation integrity or safety clearances ;
otherwise, it may causesafety hazards.
•
Install ONLY undamaged modules and components.
Do NOT attempt to modify or diassemble the solar kit components in any manner.
•
Assemble the solar kit ONLY per the instructions in this manual. Mount the inverter in such a way
•
that it cannot be touched inadvertently.
•
The installation location must be freely and safely to get at all times
In order to avoid electrical shock or other injury, inspect existing electronic or plumbing
•
installations before screwing the solar kit installation.
Use care when choosing solar kit installation location and adhere to specified cooling requirements.
•
•
Never install solar kit in environment of little or no air flow, nor dust environment. That may derate
the efficiency of the cooling.
•
Do NOT install solar kit on easily flammable materials and where flammable materials are stored.
•
Do NOT install solar kit on structures constructed of flammable or thermolabile materials.
•
Do NOT install solar kit in close proximity to condiotioned air systems
•
Do NOT mount wall brackets on residential roofs. The brackets are not designed and certified for
this type of use.
•
Mount wall brackets on a sturdy wall to prevent them from being torn off. Do NOT modify the
fixings supplied.
•
Do NOT place supports designed for high ground on a flat roof if they are not screwed to the
ground.
•
Do NOT use any other fixing method than those recommended in the installation guide.
•
Falling equipment can cause serious or even fatal injury, never mount the unit on the bracket
unless you are sure that the mounting frame is really firmly mounted, after carefully checking.
•
When installing photovoltaic modules during the day,use opaque materials to cover the
photovoltaic modules,otherwise the voltage at the module terminals will be high in the sun,which
may cause danger.
•
Do NOT install solar kit in windy or wet weather.
•
Use ONLY dry, insulated tools. Do NOT operate with wet hands.
•
In order to minimize the potential of a shock hazard due to hazardous voltages, cover the entire
solar array with dark material prior to connecting the array to any equipment.
•
WARNING : Risk of electric shock. Unauthorized removal of necessary protections, improper use,
incorrect installation and operation may lead to serious safety and shock hazards and/or equipment
damage.
Publicidad
