Olympus PT-043 Manual De Instrucciones página 45

When the product is not used for a long time, the waterproof
performance may drop because of deterioration of the O-ring etc. Before
use, always perform the advance test and the final check.
Do not apply excessive force to the tripod seat or the accessory mount.
When a flash is used while the Case is being used, shadows may
appear at the edges of the picture. This is especially notable when
taking pictures in macro mode on the wide-angle side. Please use a
flash after image confirmation.
Do not use the following chemicals for cleaning, corrosion prevention,
prevention of fogging, repair or other purposes. When these are used for
the Case directly or indirectly (with the chemicals in vaporized state),
they may cause cracking under high pressure or other problems.
Chemicals which cannot
be used
Volatile organic solvents,
chemical detergents
Anticorrosion agent
Commercial defogging
agents
Grease other than
specified silicone grease
Adhesive
Do not perform operations other than specified in this instruction
manual, do not remove or modify parts other than specified, and do not
use parts other than specified.
Any troubles in taking pictures or with the equipment resulting from the
above actions shall be outside the guarantee.
OLYMPUS IMAGING CORP. shall in no way be responsible for
accidents involving immersion of a digital camera in water.
OLYMPUS IMAGING CORP. shall not pay any compensation for
accidents (injuries or material damage) at the time of use.
Do not clean the Case with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Use pure water or
lukewarm water.
Do not use anticorrosion agents. The metal parts
use stainless steel or brass. Wash with pure
water.
Do not use commercial defogging agents. Always
use the specified desiccant silica gel.
Use only the specified silicone grease for the
silicone O-ring, as otherwise the O-ring surface
may deteriorate and water leakage may occur.
Do not use adhesive for repairs or other purposes.
When repair is required, please contact a dealer or
a service station of OLYMPUS IMAGING CORP.
Explanation
En
EN 7