Installation And Start-Up - Abus FUBE50000 Manual De Instalación Y Usuario

Installation and start-up

Choosing the installation location
To ensure that the control device and the proximity chip key reader work correctly,
ensure that there are no wires / cables, pipes, metal reinforcements or other relevant
installation components within approx. a 50 cm radius of the intended installation
location.
Electrical wires and metal objects in particular may disrupt or adversely
affect the functions or the behaviour of the proximity chip key reader.
Installing the base plate
1. Open the wireless control panel housing by
removing the screws on the bottom.
2. Use the base plate as a drilling template and
mark the holes on the wall in the previously
selected installation location.
When marking out the drill holes,
make sure there are no electrical wires
or cables, pipes or other important
components behind them.
3. Drill the holes and insert the screw anchor.
4. During operation with an external power supply, insert the cables for the power
supply unit from behind into the base plate on the control device.
5. Screw the back of the housing to the wall.
Installation and start-up
35