Abus FUBE50000 Manual De Instalación Y Usuario página 37

Start-up
LED test / software version display
If the tamper contact is open when the control device starts up, the following
LED test will be performed and the software version displayed.
(1.) All four status LEDs (sub-areas 1 to 4) flash red to confirm that they are working.
The software version of the control device is displayed in sequence by the
red "RF TX" and the green "TEST" LED. Both LEDs are located on the PCB
close to the DIP switch.
(2.) The red transmitting LED (RF TX) indicates the major software version.
(3.) The green test LED (TEST) indicates the minor software version.
Example: 2 x flashing "RF TX" (red)
version "2.1"
If the tamper contact is closed when the control device starts up, the
aforementioned tests will not be performed.
Installation and start-up
7. Insert the three AA alkaline batteries in the
battery compartment.
Make sure the polarity is correct.
Running time in emergency power mode
(in the event of a power failure) and / or
length of battery life when operating without
an external power supply is roughly 1–2
years.
The actual battery life usually depends on
which functions are used (chip key reader,
keypad lighting) and how often the control
device is used.

1 x flashing "TEST" (green)

Software
37