Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
3. OPERATION
Installing the vacuum cleaner
I.
Remove the appliance and accessories from the packaging box and check if they are in
-
good condition.
Loosen the lock and remove the upper part of the tank.
-
Attach the filter set to the bottom of the head. Fig. 2
-
-
Reinsert the upper part on the tank and use the lock to secure it.
-
Insert the battery along the channel of the top cover. Fig. 3
-
Insert the aluminium tube into the flexible tube (1), and the other end of the flexible tube
is inserted into the air inlet (2). Fig. 4
-
Use the power switch to start or stop vacuuming. Fig. 5
II. Blow function
-
Install one end of the flexible tube to the air outlet as shown. In the other end, install the
aluminium tube. Fig. 6
-
Use the power switch to start or stop the blow function.
III. Ash vacuuming
-
Only use the overheating filter.
-
When the tank is full or it is difficult to suck up more dust, the filter should be removed
and cleaned.
-
When vacuuming the ash from the chimney, the temperature of the ash must be below
40°C. Do not vacuum ashes whose fire has not been extinguished.
IV. After use
-
Press the switch to turn off the vacuum cleaner.
-
Remove the flexible tube from the appliance.
-
Press the button on the switch and pull the battery out through the conduit.
-
Charge the battery if necessary.
-
Remove the top of the product.
-
Empty the dust tank and wash it.
-
Use a cloth to dry the tank.
-
Remove the filter, clean it and wash it. Please note: If washed with water, air dry
completely before installing in the vacuum cleaner.
V.
Assembly and disassembly of the battery
-
To assemble the battery, insert it along the channel of the top cover. Fig. 3
-
To remove the battery, press the button on the battery and pull the battery out through
the battery channel.
54
Publicidad
