cecotec CONGA ASH 7000 LIBERTY Manual De Instrucciones página 55

VI. Charging the battery
- After each heavy use of the product, wait at least 20 minutes before recharging the
battery.
- Before using the ash cleaner after a period of inactivity of more than one month, fully
recharge the battery.
- Connect the power cable of the battery charger to the battery connector of the device.
Fig. 7
4. CLEANING AND MAINTENANCE
- The tank and the outer casing of the upper part must be cleaned frequently.
- The dust tank must be washed out with clean water.
- Shake the dust out of the filter to clean it. If it is necessary, it can be washed with clean
water.
- Important: if the filter is cleaned with water, allow it to dry completely before
reassembling it.
- If the device does not work satisfactorily, this is usually due to clogging of the hose or a
combination of hoses or fittings. In that case, clean the affected parts.
- When the vacuum cleaner is not used for a long period of time, the battery should be
removed and recharged regularly.
5. TROUBLESHOOTING
Problem
The motor does not
start
Possible cause
The battery is not
-
connected.
The battery does not
-
have enough battery.
The vacuum cleaner
-
was not switched on.
Solution
Make sure the battery is
-
installed correctly.
Check that the battery has been
-
charged for sufficient time.
Switch the device on.
-
Conga Ash 7000 Liberty
ENGLISH
55