Publicidad
Idiomas disponibles
Idiomas disponibles
Question/Problem - Cause
Causa
The power tool does not switch on:
• The power cord is unplugged or there is an electrical
breakdown;
• The extension cord is too long, or the cross-section of
the wire is too thin;
• The supply voltage is too low;
• Motor overheating;
Excessive vibrations:
• Loose bolts or parts;
• The blade is installed incorrectly;
• The workpiece dimensions are larger than the wall
chaser cutting capacity;
The blade vibrates or slips during operation:
• The blade is not properly secured;
Solution
• Check the plug, socket and circuit breaker;
• Remove or replace the extension cord;
Plug the power cord directly into the socket;
• Check that the supply voltage is appropriate;
• Let the power tool cool for 2 minutes and then switch it
back on;
• Tighten the bolts and secure the loose parts;
• Install the blade correctly;
• Choose workpieces according to the cutting capacity of
the power tool;
• Tighten the bolt;
Publicidad
